Hifonics BG-2500.1D

LOW NOISE PREAMPLIFIER CIRCUIT

• Maximum low voltage signal from the source unit comes into the amplifier circuit with minimal distortion.

RCA INPUTS

• Nickel-plated RCA jacks create the most effiecient High/Low Level audio connection and resist corrosion.

OPERATION MODE

• Mono only.

CROSSOVER TYPE

• Variable electronic crossovers allow for complete control of the sound.

ELECTRONIC EQUALIZER

• Control of amplifier output with on-board electronic crossover to tailor specific frequencies to speakers and subwoofers.

CLASS/TOPOLOGY

• Super D-Class™ designs which employ high-speed microprocessors with proprietary D/A conversion algorithms to efficiently control the current consumption. At very high listening levels, Hifonics amplifiers with Super D-Class circuitry result in lower distortion, higher current efficiencies and less heat than conventional D-Class amplifier designs.

OUTPUT DEVICE TECHNOLOGY

• Pro-Fi™ Output Device Technology: The Ultra-Fi™ MOSFET is designed for music production vs just electronics output power. It produces very musical high power with high efficiency for cooling and minimal distortion.

HEAT SINK

• Classic aluminum Hifonics design to minimize heat build up on the Ultra-Fi™ output devices.

POWER SUPPLY

• Simpatico Coil Design: The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices.

OUTPUT CONNECTIONS

• High temperature impact resistant nickel plated connectors with allen head set screws which allow for secure termination of wire and creates an erosion resistant seal.

CONNECTION TYPE

• Secure molded connection terminal for all Power, Ground and Speaker connections. Angled for ease of access while creating a clean wire mangement profile.

LED SYSTEM PROTECTION CIRCUITRY DIAGNOSTICS

• Monitor overload and speaker short protection with illuminated indicators on the amplifier end panel.

BASS REMOTE INCLUDED

• Wired Bass Remote allows adjustments to bass frequencies from the control which can be mounted anywhere in the vehicle.

PHASE ADJUSTMENT

• Phase 0-180°: Bass drum attack, snap requires phase between deep frequency subwoofers and upper midbass speakers.

CEA STANDARDS

• CTA-2006B Compliant. CTA stands for Consumer Technology Association and Hifonics has been a member for decades.

CLASS

• Super D Class™

TOTAL CHANNELS

• 1

POWER @ 1 OHM (CH X WATTS)

• 1 x 2500

POWER @ 2 OHMS (CH X WATTS)

• 1 x 1250

POWER @ 4 OHMS (CH X WATTS)

• 1 x 625

CROSSOVER

• Variable Electronic 12dB Per Octave

VARIABLE LOW PASS CROSSOVER 12DB PER OCTAVE

• 30Hz-250Hz

TONE CONTROL/PARAMETRIC EQ

• Built-in bass control

BASS BOOST

• 0-10dB

SUBSONIC FILTER

• 15Hz-35Hz

PHASE SHIFT

• 0-180 Degrees

VARIABLE VOLTAGE

• .2 to 9V

FREQUENCY RESPONSE

• 10Hz-500Hz

TOTAL HARMONIC DISTORTION (THD)

• < 0.10%

SPEAKER LEVEL AUDIO INPUTS

• Yes

POWER TERMINAL 12V/GND

• 2 AWG

SPEAKER TERMINAL WIRE GAUGE

• 12 AWG

FUSING

• External